How many coats of fiberglass resin need to be applied to fiberglass cloth and do I need fiberglass mats? - wood for boat interior
Rebuiding I'm inside the ship and all the wood was rotten, so I removed and replaced everything and now I am the application of FRP to wood. 1 layer will do the trick, or should I ask for more? And I've put on the mat of fiberglass cloth on the extra protection? I'm trying in this new and, from the ground up any advice you might get help!
Monday, February 15, 2010
Wood For Boat Interior How Many Coats Of Fiberglass Resin Need To Be Applied To Fiberglass Cloth And Do I Need Fiberglass Mats?
Subscribe to:
Post Comments (Atom)
6 comments:
The fabric is the strength of the resin is the glue and putty.
Expanding the area of consideration, at least a few inches longer be repaired.
As already mentioned, it is necessary to plan well in advance and must be done immediately.
Preparation is the key. Poor surface preparation will end with a bad job.
The fabric is the strength of the resin is the glue and putty.
Expanding the area of consideration, at least a few inches longer be repaired.
As already mentioned, it is necessary to plan well in advance and must be done immediately.
Preparation is the key. Poor surface preparation will end with a bad job.
You can not re-sheath fiber woven resin after curing. The more layers of tissue you have, the harder it is, but everything is done at once. The surface is attached must be sanded and cleaned prior to you. A lot of air and excess resin as possible, before they become hardened removed.
hmmm idk
Certainly need more than 1 layer. I think it would be before it is strong enough. I use the Internet to get the form and then select another layer. The carpet will use more resin, but it is much harder. You should be able to tell when the fiber is strong enough. Good luck!
The strength of the resin is very little, and its only purpose is as a bonder. Strength in fiberglass. Fiber glass fabric is stronger than the mat. The substance of the filament controls the carpet sections is random direction. Without knowing what the weight of the material works of glass and ask what part of the ship that makes it impossible to employ specialists.
Substance can be placed on a previous level, forever.
1: The previous coat is still damp.
2: The layer of sand was before drying, if
The resin is applied only to soak hard enough to the glass fiber. If you want to have a smooth surface, of course, apply enough resin to give a smooth finish. Sanding is required if you plan to paint the glass. Apply to small areas with a brush resinworks, but is needed for large areas with a paint roller. To work in every case, the work of the resin to the bottom of the glass and air. They make wheels for this purpose. They look like miniature disk farmers. Acetone is the solvent to be cleaned. Nothing else touches resin and cleaning tools.
Everyone who works, is very flammable. Be careful. Copious use of ventilation. The vapors can your lungs, or worse, ruin, death.
Post a Comment